Post 1 made on Thursday November 24, 2022 at 13:33 |
Well the day had to come eventually . my pronto Ru980 finally bit the dust recently .
The screen stopped working and wouldnt respond with new batteries, and no longer responds to laptop etc
So the hunt began for a replacement , with logiteh out of the NEW market, and support going forward in doubt, I eventually found the ProControl models.
A friendly installer would allow use of software and the remote wasnt crazy expensive.
A few hours later and im back working again !
programming is very similar to prontoedit, although easier !
add devices, most are in its existing library
then add a remote, select AUTO programing , which does most of the work for you based on your device list .
eg AMP volume controls, ch up/dwn relevant to the device in use.
edit the macros for input selection and fix a coupe of discreete power codes (from old prontoedit hex )
Job done !
|
|
|