Post 1 made on Tuesday December 8, 2015 at 22:52 |
grubermp Lurking Member |
Joined: Posts: | December 2015 2 |
|
|
Hi,
My equipment setup is:
URC MX-450 Samsung UN60F8000 Denon AVR-4520CI
When I go to turn on my whole system, I want to turn on the TV, turn on the audio receiver, and switch the audio to Cable/Sat.
And that does happen when I do turn on the system but then, mysteriously, after about 12 seconds the receiver input changes from CBL/Sat to TV Input. There is no pause and macro in the setup telling it to do this. Any reason why this might be happening?
Thanks in advance!
|
|
Post 2 made on Wednesday December 9, 2015 at 10:53 |
Mikejl Long Time Member |
Joined: Posts: | February 2003 45 |
|
|
Are you using ARC?
That happens on my configuration too because I use ARC. The the only way I could get get around it, was by adding a 20 second delay and a change input to the end of my Macro.
That way after ARC finishes running the remote sends another command to change the A/V receiver back to the correct input.
Mike
|
|
OP | Post 3 made on Thursday December 10, 2015 at 22:54 |
grubermp Lurking Member |
Joined: Posts: | December 2015 2 |
|
|
Not using ARC. Just a Xantech IR repeater system
|
|
Post 4 made on Wednesday December 16, 2015 at 17:17 |
Mikejl Long Time Member |
Joined: Posts: | February 2003 45 |
|
|
I have nothing then. ARC is the only thing I know of that does what your describing.
Mike
|
|
Post 5 made on Wednesday December 16, 2015 at 21:17 |
goldenzrule Loyal Member |
Joined: Posts: | July 2007 8,478 |
|
|
Turn off CEC on everything
|
|
Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our
Marketplace. For information on how to advertise your service or product
click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.