Post 1 made on Tuesday February 16, 2016 at 12:02 |
Bob8K Long Time Member |
Joined: Posts: | December 2015 17 |
|
|
Hi,
I need to enter program a MX-850 using HEX codes such as:
0000 006F 000C 0000 001F 0022 0020 0023 001F 0022 001F 0022 003F 0024 001F 0022 001F 0022 0020 0043 003F 0024 001F 0022 001F 0022 0020 CB8C
I cannot make the MX-850 learn these codes, its just unable to capture them correctly from the remote I need to emulate. Instead, I use a PC capture device (USB Infrared Toy V2) and IRscrutinizer. It's the only way I found to make the MX-850 work with this particular remote codes.
The problem is that, for Volume UP for example, the MX-850 does not repeat sending when keeping the Vol UP key down.
When learning a code, I can trigger the repeat by making it learn while keeping down the sending remote, but that's not possible here.
How can I make a key repeat with the HEX editor?
|
Robert |
|
OP | Post 2 made on Thursday February 18, 2016 at 08:45 |
Bob8K Long Time Member |
Joined: Posts: | December 2015 17 |
|
|
Found out the answer thanks to the JP1 Remotes folks, I need to switch "000C 0000" with "0000 000C".
|
Robert |
|
Please read the following: Unsolicited commercial advertisements are absolutely not permitted on this forum. Other private buy & sell messages should be posted to our
Marketplace. For information on how to advertise your service or product
click here. Remote Central reserves the right to remove or modify any post that is deemed inappropriate.